Introduction
Specifications
1
1-4
doc072919
Introduction
1.3
Specifications
1.4
1.5
Warranty
Wood-Mizer
®
LLC
Limited Product Warranty
Wood-Mizer LLC (“Warrantor”), an Indiana corporation with its principal place of business at 8180 West Tenth
Street, Indianapolis, IN 46214-2400 USA, warrants to the original purchaser (“Purchaser”) that for the time
periods specifically stated herein and subject to the terms, conditions and limitations stated herein, the equip-
ment manufactured by the Warrantor will be free from defects in material and workmanship attributable to
FS-350 Wood Splitter
Standard
Power
Engine
Honda gas 390CC
Tonnage
29-T @ 3000psi
Hydraulic pump
22 gpm 2 stage
1
1
Single vs 2-stage pumps
: A single-stage pump has only one maximum pressure and one flow rate. Single-stage pumps
are typically attached to the crankshaft or PTO shaft on a farm tractor or large industrial engine. Two-stage pumps are
typically mounted to small gas or diesel engines. A two-stage pump will first produce high volumes of fluid, moving the
cylinder in and out quickly. When the pump receives resistance, a second set of gears will produce high pressures for lifting
or splitting. However, the volume of fluid will drop considerably during this stage. This mechanism has many practical ap-
plications. For example, in wood splitters equipped with a two-stage pump, in stage one, the rod travels faster up the cradle
until the rod starts to split the wood. At that point, the speed slows but the force increases.
Dimension
Length:
Width:
Height:
120 in
72 in
36 in
Weight
2050 lbs
Operation
Hydraulic pressure
2500 psi
Hydraulic fluid
2
2
For operating temperatures -20° to 100° F (-29° to 38° C), use an all-weather Hydraulic fluid conforming to ISO-32 stan-
dards, such as Conoco MV32. For other operating temperatures, See Section “4.2” Hydraulics.
18 gal tank + 5 gal system
Cycle time
6.5 seconds
