Stand Assembly
3-2
WM doc 1/20/21
3
3.1
Stand Assembly
The sharpener can be used directly on a surface or the ground. Alternatively, it can be
used at a standing height. When used at a standing height, the sharpener is elevated by
three legs that are fastened to the base of the sharpener. The stand is composed of these
parts:
Six carriage bolts
Six wing nuts
Three upper legs
Three compression couplings
Three lower legs
Assemble the stand:
1.
Assemble the lower and upper legs with the compression coupling.
a.
Fasten the lower leg into one end of the compression coupling by inserting the leg
into the coupling and twisting the ring on the coupling until it tightens onto the leg.
b.
Fasten the upper leg into the other end of the compression coupling by inserting
the leg into the coupling and twisting the ring on the coupling until it tightens onto
the leg.
NOTE:
Ensure that the end of the upper leg with holes is not inserted
into the coupling.
NOTE:
Hand tightening the compression couplings is sufficient. It is
only necessary to use enough force to make the ring clamp onto the
leg. However, the gauge used to set the hook angle has a wrench built
