Wood Bros 3200NT, Service Manual

Page: 9 / 24

3200NT Timer
9
Timer Programming Mode
1. Enter
3200NT
Programming Mode
Press and hold both the Set Up and Set Down buttons for
five (5) seconds to enter Programming Mode. When the
program mode is entered, the program light illuminates.
2. Set Feed Water Hardness
The feed water hardness setting displays only if the
Regeneration Type is set to Meter Immediate or Meter
Delayed.
— Press the Set Up and Set Down buttons to set the
amount of feed water hardness (in grains/gallon). The
system automatically calculates treated water capacity
based on the feed water hardness and the system
capacity.
— Press the Extra Cycle button to proceed to the next
step.
3. Set Regeneration Time
A non-flashing colon between two sets of numbers
identifies the
Regeneration Time display. Set the desired
time of day that you want Regeneration to occur.
— Press the Set Up and Set Down buttons to adjust this
value.
— Press the Extra Cycle button to proceed to the next
step.
4. Set Regeneration Day Override
Us this display to set the maximum amount of time (in
days) the unit can be
In Service without a Regeneration .
— For System 4 Time Clock regeneration mode the
system regenerates at the time set in Step 4 after the
number of days programmed in this step.
— For all other System Types (4 Meter Immediate,
4 Meter Delayed, 5, 6, 7, 9) the system regenerates
after the number of days programmed in this step
unless the meter initiates a
Regeneration cycle
earlier.
— Press the Extra Cycle button to proceed to the next
step.
Timer programming is complete and exits from the
Programming Mode. Normal operation resumes.