3
Ventilation requirements
Note: see convector instructions if being installed within a Wonderfire convector box for
ventilation requirements.
GB
A permanent ventilation grille
of fixed design and having a
minimum free area of 100cm
2
must be fitted with direct
access to outside air to room.
IE
Ventilation must be in
accordance with IS 813 1996
(as amended)
Please note: This appliance is not
supplied with a decorative
firefront. A slotted firefront with a
minimum free area as shown
in figure 2 must always be used.
OPERATION OF THE FIRE
This fire is controlled by a four position gas tap mounted in the front of the appliance.
In addition to the OFF setting there is a pilot position and two heat control settings.
To Light the Pilot
Ensure that the control knob is turned to the OFF position. Depress the control knob
and turn anticlockwise until the IGNITION position is reached, continue turning the
knob to activate the piezo ignition. Two ‘clicks’ will be observed, and the pilot should
ignite. Hold the knob in this position (keeping it depressed) for ten seconds to allow
the flame supervision device to establish.
Observe if it alight by looking through the slots to the left hand end of the front coals.
If the pilot does not light immediately, repeat the above procedure, keeping the knob
depressed for several seconds in order to purge any air from the system.
If after ten seconds, ignition has not occurred, turn the control knob back to the OFF
position and repeat the ignition procedure after 3 minutes.
Once the pilot is lit, keep the control knob depressed for ten seconds to allow the
flame supervision device to establish.
When the control knob is released, the pilot should remain lit. If the pilot fails to
remain lit, repeat the ignition procedure, this time keeping the control knob depressed
for a longer period of time.
Lighting the Main Burner
Once the pilot light is established the main burner can be lit by turning the control
knob anticlockwise to the HIGH position.
Controlling the heat setting.
Figure 2
