FILTER CLEANING
8
• Turn OFF water supply.
• Lift the Handle (1) and rotate the Filter
counterclockwise while holding the Rotating
Dial still.
9
Once Filter is released, lift to remove the Filter (1).
10
Clean and reinstall the Filter (1) by rotating the
handle clockwise while holding the Rotating Dial
(2).
11
Turn ON water supplies and check for leaks.
TROUBLESHOOTING
Issue: Water surface is too high or too low
Cause: Inlet Valve is not adjusted to the desired position.
Solution: Adjust water level by following the “Water Level
Adjustment” section.
Issue: Inlet Valve does not turn on
Cause: Water Supply is off.
Solution: Turn on Water Supply. If Fill Valve is still not functional, turn
off Water Supply and clean Filter Screen by following the “Filter
Cleaning” section in the IOM.
Issue: Inlet Valve does not turn off
Cause: Refill Tube wasn’t installed properly.
Solution: Re-install the Refill Tube by following
Step 4
of the “Fill
Valve Install” section.
CALIFORNIA PROPOSITION 65:
WARNING:
This product can expose you to chemicals including lead, which is known to
the State of California to cause cancer and birth defects or other reproductive harm. For
more information go to www. P65Warnings.ca.gov.
Wash hands after installation, repair, or removal of this product.
PRODUCT WARRANTY:
With exception of items listed below, this product has a limited warranty against
defects in materials or workmanship for a period of one year from the date of
purchase.
Warranty is limited to replacement of defective components or units.
Associated
replacement or repair labor costs are NOT included. This warranty only pertains to single dwelling
residential use. Valves used for other than single dwelling residential use are covered by a 5 year limited
warranty from the date of purchase.
87750 / 87751 ROUGH-IN DIAGRAM
DIMENSIONS SUBJECT TO CHANGE WITHOUT NOTICE.
2 12 "
64mm
2 18 "
54mm
3 1
16 "
77mm
8 3/4in [223mm] MIN
12 1/2in [317mm] MAX
11
16 "
18mm
15/16-14 UNS-1
FIT 7/8" BALLCOCK
6in [150mm] MIN
9 5/8in [245mm] MAX
WATER LEVEL
R 78 "
22mm
COMPLIANCE:
CONNECTIONS:
ASME A112.18.1
Contractor to supply necessary inlet
connections.