800-944-9292
www.wolverinebrass.com
NEED HELP?
For additional assistance or service please contact:
92-87750-02
Installation Instructions
87750
87751
Adjustable
Wrench
TOOLS AND SUPPLIES NEEDED
NOTE
• When installing the fill valve, the critical level on
the fill valve (identified on the valve marked "CL ")
should be at least 1" (25.4mm) above the top of the
overflow pipe of the flush valve. This will ensure code
compliance.
• Do not install this product using any additional
sealants.
• Water Temperature: 2°F to 45°F
• Fill valve operating pressure range: 30-120psi
IMPORTANT
SAFETY TIPS:
• Cover your drain to prevent loss of parts.
• Be sure to read instructions thoroughly before
beginning installation.
• Inspect all connections after installation.
•
NOTE:
This installation manual covers several
models of the Toilet Fill Valve. While the
appearance of your Toilet Fill Valve may differ
from those shown, the installation method is the
same.
WARRANTY:
Warranty information can be found at:
www.wolverinebrass.com
WARNING
DO NOT OVER-TIGHTEN
CONNECTIONS OR
DAMAGE MAY OCCUR.
DO NOT USE CHLORINE OR
ANY CHEMICALLY RELATED
COMPONENTS AS THIS
WILL RESULT IN DAMAGE
TO TANK COMPONENTS
AND MAY CAUSE
FLOODING AND PROPERTY
DAMAGE.
USE OF CHLORINE OR
CHEMICALLY RELATED
COMPONENTS WILL VOID
WARRANTY.
!
PREPARING INSTALLATION
1
• Turn OFF water supplies.
• Drain Toilet Tank completely.
• Remove existing Fill Valve.
• Remove any debris and
thoroughly clean mating
surfaces.
FILL VALVE INSTALLATION
2
Unscrew and remove the Quick Connect
Mounting Nut (1). Connect the Refill Tube to the
Fill Valve prior to installation (2).
3
Insert the Fill Valve (1) into the mounting hole
located at the bottom of the tank.
• From below, install the Quick Connect Nut.
The Quick Connect Nut can be easily installed by
sliding the Quick Connect Nut upwards until it
makes contact, then rotating clockwise to hand
tighten
(2).
•
NOTE:
Do not over-tighten any connections or
damage may occur.
REFILL
TUBE
x
WATER
LEVEL
4
Connect the Refill Tube (1) to the overflow outlet
of the flush valve.
•
NOTE:
Make sure the Refill Tube is above
water surface.
5
Install Water Supply Line (1) (not supplied) to the
Shank of the Fill Valve. Take care to not
over-tighten or damage may occur. Turn ON
water supplies and check for leaks.
WATER LEVEL ADJUSTMENT
6
The Fill Valve is factory set to the lowest water level possible.
To increase water level
, turn the Rotating Dial counterclockwise (1) while holding the body of the Fill Valve
to prevent any unnecessary movement.
• There are 24 marked dots on the Rotating Dial. Each dot represents a level of adjustment in regards to the
water level in tank.
7
To decrease water level
, turn the Rotating Dial clockwise (1).