If you want to work with more than one Visualizer in the same room, the units should be set to different
infrared codes, in order to control them all individually.
To change the IR code, enter the
"Miscellaneous Settings" and set the "IR Code" to
A, B, C or D (code A is default). To change the IR code on the remote control, simultaneously press
FOCUS,
SCROLL
and
TELE
ress
FOCUS, SCROLL
and
WIDE
on-screen menu, go to
. Each time this key combination is used, the code switches from A to B, C, D ... A ... in
the order given.
For resetting the remote control to code A, simultaneously p
.
The LED shows the selected code (it flashes one time for code A, two times for code B, three times for code
C and four times for code D).
Different IR Codes
Please note that an infrared remote control can only be used up to a certain distance
from the unit. Objects situated between the Visualizer and the infrared remote control,
and weak batteries, interfere with reception.
If the Visualizer can only be controlled from a close distance, or if it cannot be
controlled at all with the infrared remote control, you may have to change the
batteries.
Open the cover on the back of the remote control and replace the two
1.5 V AA batteries with new ones.
Check the polarity of the batteries!
Recycle the batteries!
Batteries
back (open)
-
+
-
+
X
X
22
Disconnect the power cord
(#26)
before changing the fuses!
The fuses are situated behind a small lid at the power socket. It can
easily be opened with a small screwdriver etc.
Remove the socket, exchange the fuse(s) carefully, and put back the
socket the right way round into the socket holder.
The type of fuse is: F 1.5A.
Do not use any other type !
Change the fuses for new ones and switch the unit on.
If the fuses fail again contact your dealer!
Exchanging Fuses
Always use the POWER key on the side of the Visualizer to move the arm!
Follow the next steps only when the motorized arm is not working properly.
Switch off and on the unit by using the mains switch and try it again with the ARM key (keep the POWER key
on the unit pressed until the arm starts to move down).
In case the arm is still not working,
Do not push-in the telescope manually to prevent damages on the arm mechanism!
Disconnect the unit from mains.
To move-in the telescope, use a flat screw driver and turn the shaft which is found in the hole on the side of
the unit at the arm-pivotal centre.
To swivel the arm down, turn the mirror until it is parallel to the arm. Remove the plastic cap below the arm /
beside the connector panel to access motor shaft. Use a flat screw driver to turn shaft.
please contact your WolfVision dealer.
Moving the arm manually
(stopgap solution when the motorized arm is defective)
