2
I. Installing the E-‐Base.
A Kiowa Heat Shield (HS402) is a MUST. As Wolfman Does not Warranty Heat Melt.
There are three methods of mounting the E-‐Base on your bike, depending on how your bike is set up.
A.
Tension-‐O-‐Matic rear Strap
. **No Rack or space above tail light on bike. **
1. Place E-‐Base across the seat and rear fender of your bike. Fig.4
Fig.4
Fig.5
2. Place the Tension-‐O-‐Matic strap on the rear fender. Fig.5
3. Spread the Gutter Hooks of the Tension-‐O-‐Matic mounting across the rear fender so the Gutter Hooks catch the
bottom lip on each side of the rear fender. Fig.5
Fig.6
Fig.7
4. Pull the Tension-‐O-‐Matic strap away from the rear fender to tension straps.Fig.6
5. Thread Tension-‐O-‐Matic straps through rear buckles and Tighten straps to set seat position-‐ **Tip: for more seat
space, position E-‐Base further back on seat and fender. Fig.7
B.
Single Rear Strap.
This method uses the Space Between the tail light and rear fender.
1. Place E-‐Base across the seat and rear fender of your bike. Fig.8
Fig.8
Fig.9
2. Slide Rear Strap Between Taillight and Fender, towards seat until it stops. Fig.9
3. Tighten rear Strap to set seat position-‐**Tip: for more seat space, position E-‐Base further back on seat and fender.
Fig.10
