Figure 1
Figure 2
Slicer/Shredder Assembly and Use
Slicer/Shredder Disc Assembly
1
Place WORK BOWL with NONSKID RING attached on a flat, level, stable
surface.
2
Place the PROCESSOR SPINDLE over the pin a the bottom of the WORK
BOWL.
3
Assemble the desired attachment (SLICER or SHREDDER BLADE)
according to the section “Slicer/Shredder Disc Assembly”.
4
Place the assembled SLICER SHREDDER BLADE DISC on top of the spindle
and push down until it stops. It will not click into place.
5 WARNING:
Never handle SLICER/SHREDDER DISC by the blade itself.
Blades are sharp! Always handle by two finger holes opposite each other
on the DISC to avoid a laceration injury.
6
Place the assembled PROCESSOR SPINDLE over the pin at the bottom of
the WORK BOWL.
7
Place the WORK BOWL LID onto the WORK BOWL by aligning the UNLOCK
symbol on the LID with the ARROW on the WORK BOWL HANDLE.
8
Turn LID counter-clockwise until the LOCK symbol is aligned with arrow on
the WORK BOWL HANDLE.
9
Place the MOTOR HOUSING into the MOTOR HOUSING RECEPTACLE
of the LID by aligning arrow of the MOTOR HOUSING over the UNLOCK
symbol on the MOTOR HOUSING RECEPTACLE.
10
Turn the MOTOR HOUSING CLOCKWISE to align the MOTOR HOUSING
with the lock symbol on the MOTOR HOUSING RECEPTACLE.
11
Plug the MOTOR BASE into 120-volt 60 Hz AC only outlet.
12
Use the LOW SPEED BUTTON and place food to be processed into the
HOPPER. Do not use excessive force to push food into the hopper as this
will result in uneven processing.
WARNING:
Never use fingers to push food into HOPPER to avoid a laceration
injury. Once food height reaches the top of the HOPPER use the FOOD
PUSHER to continue processing.
When you are finished, simply release the SPEED BUTTON and unplug the
MOTOR BASE.
Remove MOTOR BASE from the LID, then remove the LID from the WORK
BOWL.
Remove the assembled SLICER SHREDDER BLADE DISC and SPINDLE from
the WORK BOWL before removing you food.
To remove the selected blade from the DISC hold the DISC firmly while pushing
the BLADE up from the bottom of the DISC until it pops up. Carefully remove
from the DISC
WARNING:
Never handle BLADES by the blade itself. Blades are sharp! Always
pop out of disc from the underside of the DISC only to avoid a laceration injury.
1
Place SLICER/SHREDDER BLADE DISC on a flat service.
2
Hold the selected blade opposite the sharpened side and tilt into BLADE
DISC as shown if Figure 1 at an angle.
3
Press the blade down into the disc until it clicks into place and is flush with
DISC HOLDER as show in Figure 2.
4 WARNING:
Blades are sharp, never grasp or touch blade when handling to
avoid a laceration injury.
Sharpened
Side
Push Blade
in From Side
Opposite
Sharpened Side
9
10
