Wiring
Connect the LT1 to the tanning bed using the white header connector on the back of the circuit board.
See the diagram.
Session Control
To start a session, press the Set button on the LT1. The
time will go to the maximum time then count down.
The lamps will turn on automatically. You can decrease
the time by pressing the Set button. To cancel a session,
press the Start/Stop button on the LT1. The display will
go to a 0.
JP2 JP1
Pin 3 - Neutral or L2
Pin 2 - AC HOT or L1
Pin 1 - Output
110V
110V
220V
Removal of Acrylic
Remove black acrylic locking strips first. To remove the acrylic locking strip, insert a flat head screwdriver
into the front edge of the locking strip and pry up. After Acrylic locking strip is removed, go to the head
of the bed. Place the flat head screwdriver between the acrylic and aluminum extrusion. You will then lift
the acrylic up enough to get your hand under it. Please use a glove due to the acrylic is very sharp and will
cut an unprotected hand. With your hand placed between the acrylic and extrusion, lift up on the acrylic
until it pops out of the extrusion. Lift the acrylic out of the bed.
Replacing Acrylic
Insert Acrylic into aluminum extrusion lip in back of bed. Apply pressure to back aluminum extrusion while
pushing acrylic down into the bed until it pops into the front aluminum extrusion. Replace black acrylic
locking strips.
Care and Maintenance
Cleaning After Use
Clean and disinfect your tanning bed’s bench and canopy after each use. Use a non-abrasive disinfectant
cleaner that does not contain ammonia or ammonia derivitaves. Ammonia may damage the acrylic
shield. Spray the acrylic lightly with disinfectant and wipe dry with a clean soft cloth. Wipe the canopy grill
with a soft cloth slightly dampened with disinfectant, then wipe dry.
Thorough Periodic Cleaning
The cooling fans draw air through the bed and will cause a dust buildup on the lamps and reflectors.
When a dust buildup is observed, it is necessary to thoroughly clean the inside of the bench and canopy.
1) Remove the acrylic shield, metal grill and lamps.
2) With a soft cloth, wipe the entire length of each lamp.
3) Clean both sides of the acrylic shield and grill with a non-ammonia disinfectant cleaner.
4) Wipe the reflectors with a clean damp cloth.
5) Re-install the lamps, acrylic shield and grill.
Mechanical Inspection
• Inspect the unit’s fasteners verifying that all are firmly in place. Pay particular attention to the hinge bolts.
• Inspect gas springs for signs of wear. Replace gas springs that will not hold the canopy in the fully open
position when raised.
• Inspect the AC power cord and its connections.
• Inspect the acrylic. Replace if broken, cracked or badly scratched.
