The following lamps have been certified for use in the Solar Storm
16R, 24S, 24SR, 24R, 32S or 32R models:
2645 Inferno Wolff lamps (15 minute)
1704 FT LSI lamps (20 minute)
2393 CC 5.0 Wolff lamps (20 minute)
1705 BT LSI lamps (20 minute)
Electrical Requirements
Your sunbed operates from a 120V or 220V AC source. For 120V models, you should have a standard
electrical outlet on a dedicated 20 Amp Circuit Breaker. For 220V models, you should have a NEMA 6-20R
Electrical outlet on a dedicated 20 Amp Circuit Breaker installed in the room in which you will use the unit.
For SS32R models, 30 Amp service will need to be hard-wired to the bed. We recommend installation
by a professional electrician. The outlet must be earth grounded.
DANGER
Shock hazard.
Disconnect power before servicing
or removing any protective covers.
Do not operate this device near
water or while you are wet.
DANGER
Some medications may increase your
sensitivity to ultraviolet light. It is
recommended that you consult a physician
before using this sunbed if taking any
medication or if you suspect that your skin
might be especially sensitive to sunlight.
WARNING
Wear protective eyewear. Failure to may result in severe burns or long term injury to the eyes.
CAUTION
Air from the room is used to cool the sunbed. Maximum ambient room temperature should be
80
o
F. Place your sunbed no closer than 6" from any wall. Make sure nothing obstructs the
airflow into the sunbed's endcaps or out of the fan openings. A poorly ventilated room may
cause the unit to become hot and cause discomfort to the user.
Unpacking and Inspection
Your sunbed comes in two cardboard cartons. Pull back the plastic sheet and, with a helper, grasp
the bench and pull it from the carton bottom, leaving the plastic wrap and the carton packaging.
Do not try to lift the unit with the plastic still on as it may slip. Do the same with the canopy.
The canopy box contains the canopy and a pair of gas springs. The bench box contains the bench,
assembly hardware and stand legs. Inspect the items and make sure they are free from any visible
damage. Report the extent of any damage to the transportation company.
Hardware Inventory
!
!
!
!
Allen-head Bolt 5/16 X 1”
Quantity 6
5/16” Metal Washer
Quantity 10
Allen-head Bolt 5/16 X 1.5”
Quantity 4
Hinge Brackets
(1) Left, (1) Right
Hex (Allen) Wrench
Quantity 1
Safety Goggles
Quantity 1
Standard 120V
NEMA 6-20
(220V)
120V/240V Outlets
