
17
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 | www.wolff-tools.de
EN
5.0 Transport
To avoid injury dismount the blade while transporting
the machine. Pull out the plug from the mains.
6.0 Maintenance
Maintenance and Cleaning
► Before any work on the machine itself, pull the
mains plug.
► For safe and proper working, always keep the ma-
chine and ventilation slots clean. The machine
must then be sent to an after-sales Service agent.
Addresses are listed in the Section “After- sales
service and customer assistance”.
► The motor is equipped with shut-off charcoal which
shuts off the motor when the wear limit is reached.
If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should
be carried out by an after-sales service centre for
WOLFF power tools.
In all correspondence and spare parts orders, please
always include the machine number specified on the
type plate of the machine.
6.1 Spare parts
Spare parts are available on the Internet:
http://webcatalog.wolff-tools.com can be found.
7.0 Trouble shooting
Fault
Possible cause Remedy
8.0 Disposal information
Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an environmen-
tally correct manner.
Subject to change without notice
9.0 Notes on various floor coverings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The DURO STRIPPER 2.0 is primarily used to remo-
ve linoleum, PVC, rubber, cork, design, and CV
coverings as well as needle-punched floor cover-
ing and carpeted flooring.
Hardwood parquet, multi-layer parquet, semiflexib-
le and ceramic tiles can also be removed to a limi-
ted extent.
► Needle-punched floor covering, carpet, PVC…..
The coverings to be removed should be pre-cut in
blade-widths (Pic. D) and then removed with the
stripper in one step. In many cases, the glue can
also be removed at the same time.
► Coverings without a foam backing:
Prior to performing the stripping work, pre-cut the
strips in blade-widths (Pic. D). Regularly check
whether the blade is still straight and sharp.
► Coverings with a foam backing:
Only use sharp blades! Remove the large Sections of
the wearing surface. Use a carpet pulling claw for this.
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from the
side.
The machine
does not start
Power supply
interrupted
Defective cable
Defective plug
Contact Electrici
-
an.For repair and
/or replace parts
Higher exer
-
tion of force
required while
working
Cutting bla
-
de dull
Replace
cutting blade
or resharpen
Machine
shuts off
Coal worn
out
Replaced coals in
service workshop