WOLFF 083124, Use And Maintenance

Page: 40 / 86

ENGLISH - 16
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
If the levers on the handle bar
are pressed, the machi- ne
does not start. Low battery (battery version
only).
Plug disconnected (charger
version only).
Check that the battery is
charged.
Connect the plug.
The brush does not rotate. Levers on the handle bar not
pressed.
Brush rotation enabling but-
ton not pressed.
Brush motor damaged.
Press the levers.
Press the button.
Replace the engine.
Aspirator does not work. Vacuum cleaner turned off.
Intake motor damaged
Start the vacuum cleaner by
pressing the corresponding
button.
Replace the turbine.
The machine does not dry
well, leaving traces of water
on the floor.
Aspirator off.
Obstructed vacuum tubes.
Dirty wiper rubber blades.
Squeegee rubber blades
worn.
Start the vacuum cleaner by
pressing the corresponding
button.
Check and if necessary cle-
an the vacuum tubes that
connect the wipers to the re-
covery tank.
Clean the rubber blades of
the wiper.
Replace or turn over the
squeegee rubber blades.
The machine turns off. Low battery.
Recovery tank full.
Charge battery.
Empty the tank.
No water comes out. Tank empty.
Filter blocked.
Pump not functioning.
Fill the tank.
Clean the filter.
Call the technical support
service.
Insufficient floor cleaning. Inadequate brush or deter-
gent.
Brush worn.
Use brush or detergents
adequate to the type of floor
or dirt to be cleaned.
Replace the brush.