Wolfcraft 3001000, Translation Of The Original Operating Instructions

Page: 17 / 76

17
Intended use
• The wood jointer is an attachment for mains- or battery-operated
drilling machines with a collar diameter of 43 mm.
• The wood jointer is suitable for milling profiles, slots and grooves.
• The maximum jointer speed of 5,000 rpm must not be exceeded.
• The correct direction of rotation of the jointer must be ensured during
assembly. It is therefore imperative to note the arrow on the device
housing, indicating the direction of rotation. The jointer is exclusively
designed for up-cut milling.
Operating instructions
1. Ensure that your cutting tools are always sharpened. Blunt will give you
bad milling results and can “ kick back“ which could be dangerous
as well as overloading your power machine.
2. When removing a thick amount of material, then make several passes
( rough out and then make a fine cut ). It will save wear on your power
machine and cutting tools.
3. An even and gentle movement will prolong the life of your cutters,
prevents friction, burning on wood and overloading the motor.
t
Symbols and meanings
Safety instructions
• It is essential to comply with the safety instructions of the manufacturers
who made your drive machines.
• These appliances must conform to the VDE regulations. Appliances built
after 1995 must have CE certification.
Warning of general danger Wear ear protection.
Wear a dust mask.
Pull out mains plug
Read instructions/
information.
Wear safety goggles.
Bdal 3001.000_116313001 18.11.15 16:15 Seite 17