wolfappliance.com
|
5
Troubleshooting
IMPORTANT NOTE:
If the vacuum seal drawer does not
operate properly, follow these troubleshooting steps:
•
Verify electrical power is supplied to the unit.
•
Verify proper electrical connections.
•
If the vacuum seal drawer does not operate properly,
contact Wolf Factory Certified Service. Do not attempt to
repair the appliance. Wolf is not responsible for service
required to correct a faulty installation.
Preparation
Remove and recycle packing materials. Do not discard the
package containing the two screws provided for installation.
Install an anti-tip block against the rear cabinet wall. Verify
the screws are adequately secured and do not penetrate
electrical wiring or plumbing.
IMPORTANT NOTE:
The installation hardware is provided
with the accessory front panel.
INSTALLATION
SHIPPING
SCREWS
MOUNTING
HOLE
Shipping screw location
Mounting hole location
Installation
1
Turn off power to the electrical outlet.
2
Place the unit on a protected work surface and remove
the two shipping screws from the back of the unit. Refer
to the illustration below.
3
Place the unit near the opening and plug the power cord
into the receptacle.
4
Slide the unit into the opening.
5
Open the drawer to full extension.
6
Drill a pilot hole in each mounting hole location. Refer
to the illustration below.
7
Secure the unit with the provided screws.
8
Turn on the electrical supply to the outlet and verify
operation.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
TROUBLESHOOTING
