Wolf OG30, Technical & Service Manual

Page: 34 / 54

Outdoor Grill (OG) Series
Component Access / Removal
4-6
#814144 - Revision A - July, 2009
Control Knob Bezel
Control knob bezels are attached to the front panel with
screws.
To remove a control knob bezel, first remove the control
knob in front of it, then extract the bezel mounting
screws and pull the bezel from the front panel. (See
Figure 4-9)
Front Panel Assembly
The front panel assembly is attached to the landing
ledge with screws. One screw passes up through a
hole at each end of the front panel’s upper and lower
flange and into the landing ledge.
To remove a front panel assembly, first remove all con-
trol knobs, then (See Figure 4-10):
1. Pull drip tray to its full open position, but do NOT
remove the drip tray assembly.
NOTE: This will allow for the front panel assembly
to rest on the tray during service.
2. Extract the screws from each corner of the front
panel and lay it face down on the drip tray.
NOTE: Place rags or cardboard between the drip
tray and the front panel to avoid damaging the front
panel.
3. Disconnect electrical leads from lights power switch
and LED light harness, then set panel assembly off
to the side.
Front Panel LED Lights
The front panel LED lights are part of individual wire
harnesses, with the LED’s fitting down into sockets that
are attached to the top flange of the front panel.
To remove a LED light harness, first detach the front
panel from the landing ledge as described in steps 1
and 2 of Front Panel Assembly removal instructions,
then (See Figure 4-11):
1. Disconnect electrical leads of defective LED har-
ness.
2. Pull LED from socket.
Figure 4-9. Bezel Removal
Figure 4-10. Front Panel Removal
Figure 4-11. LED Lights Removal
Bezel
Front Panel Assembly
LED Harnesses