Component Access / Removal
Outdoor Grill (OG) Series
4-3
#814144 - Revision A - july, 2009
Drip Pan Assembly
The drip pan assembly rides on rollers at the front bot-
tom of the grill chassis, with two rollers attached to the
rear of the pan fitting in channels on each side of the
grill chassis.
To remove a drip pan assembly (See Figure 4-1):
1.
Pull drip pan forward until it stops.
2.
Lift front of pan up while pulling it farther forward to
bypass stop point.
3.
Drop front of pan down while lifting rear rollers over
front rollers.
Halogen Lamp (Bulb)
To remove an interior halogen lamp (See Figure 4-2):
1.
Use a small flat blade screwdriver or similar device
to pry lamp lens from the lens retainer clips.
2.
Pull halogen lamp from lamp base.
NOTE:
When installing a new halogen lamp, avoid
touching the lamp with bare skin, as the natural oils
from skin can shorten the life of a halogen bulb. Use a
soft cotton cloth or gloves to install the lamp.
Thermometer
The body of the thermometer fits into holes in the hood
and hood liner, with a nut inside the hood assembly
threaded onto the body of the thermometer holding it in
place.
To remove the thermometer (See Figure 4-3):
1.
Open hood, then use a 1” open-end wrench or
crescent wrench to remove retaining nut from back
side of thermometer.
2.
Pull thermometer from front, top side of hood.
NOTE:
When reinstalling thermometer, be sure weep
hole is oriented down when hood is closed.
Figure 4-1. Drip Pan Assembly Removal
Figure 4-3. Thermometer Removal
4-2. Halogen Lamp Removal
Thermometer
Nut
Drip T
ray
Lens
Lamp
Lamp base and
housing inside
rear hood
assembly
Hood
Summary of Contents for OG30
