13
DCL-200 FD
Note:
Wolf Cinema always recommends that you, your custom installer or video calibrator thoroughly test the HDMI video
cable(s) with the entire system prior to final installation. HDMI cables vary greatly in overall quality and signal integrity.
Many HDMI cables are not designed to support certain information and signal timings over long cable runs. Contact Wolf
Cinema technical support and/or your cable manufacturer for additional information regarding recommended HDMI
cable lengths and overall system compatibility.
Note:
Use extreme care when connecting AC Power to any products. Review the important safety notices indicated on pages
1-3 of this manual.
Note:
The GPIO port not used in the DCL-200FD system. It is reserved for discrete
communication protocol between the ProScaler and our DCX-series of video
projectors. Leave disconnected.
3
RS-232:
Route and connect any 9-pin RS-232 cables from your external home automation or control system, separately
to both Projector and ProScaler. These two components should be controlled independently.
5 Power on the two components:
ProScaler:
The ProScaler will automatically turn on. If a Red LED is shown on the right side of the front panel, the scaler is
receiving AC power but no video input signal is detected. If a Blue LED is shown, the scaler is receiving AC power and a good
video signal has been detected. No LED indicates there is no AC power to the scaler.
If the ProScaler does not turn on automatically, depress the
SCALER
button on the lower left of the system remote control and
then depress the green POWER
ON
button at the top.
RS-232 interconnect between ProScaler and external control system
Step 1
- Select the
SCALER
button to
activate all the
ProScaler IR
commands via the
remote control
Step 2
- Aim the
remote at the
ProScaler. Select the
green
POWER ON
button to turn on
the ProScaler
4 Connect both Projector and ProScaler to AC power.
X
Summary of Contents for DCL-200 FD
Page 1: ...DCL 200 FD...
