Planning Information
New 30"
(762)
Induction Cooktop
M O D E L C T 3 0 I / S
Dimensions in parentheses are in
millimeters unless otherwise specified.
5
I N S T A L L A T I O N N O T E S
Refer to the illustrations and specifications
for overall dimensions, cut-out dimensions and
installation specifics.
Wolf recommends using 33" (838) cabinets
with the 30" (762) induction cooktop.
Clearance is required for the terminal block
located on the bottom of the cooktop in the
right rear corner.
IMPORTANT NOTE:
A minimum height clear-
ance of 6" (152) is required between the coun-
tertop and any combustible surface directly
below the cooktop. This includes upper edges
of drawers located directly below unit. If a shelf
is installed below the unit, a 1" (25) gap at the
rear of the cabinet shelf is necessary to allow
for proper ventilation. Failure to do so could
result in decreased performance or product
damage.
A Wolf downdraft system, Cooktop or
Pro ventilation hood is recommended. When
installing a ventilation hood, refer to the specific
requirements of the hood for the minimum
dimension to countertop. Also refer to the
ventilation recommendation charts in the
cooktop or Pro ventilation sections of our
website, wolfappliance.com.
The Wolf 30" (762) induction cooktop
requires a separate, grounded 3-wire 240/208 V
AC, 50/60 Hz, 40 amp service with its own
circuit breaker. It has a 4' (1.2 m) flexible 3-wire
conduit for connection at the electrical supply.
Locate electrical within the shaded area shown
in the Installation illustration on page 4.
A Wolf built-in single oven may be installed
below this cooktop. For this installation, the
electrical supply for the cooktop should be
installed in the adjacent cabinet. Refer to page 6
for specifications. Be aware of the depth of the
cooktop when planning for this installation.
IMPORTANT NOTE:
When a built-in oven is
installed below the cooktop, unless you are
using cabinets deeper than 24" (610), it is
recommended that the electrical supply be
placed in an adjacent cabinet within reach of
the conduit.
IMPORTANT NOTE:
Wolf induction cooktops
are designed and agency approved for installa-
tion with Wolf built-in ovens only.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
If the 30" (762) induction cooktop is to be
used with any combination of additional
cooktop units or modules with a filler strip, the
cut-out width increases to 29" (737). When
multiple cooktops or modules are installed side
by side, refer to the countertop cut-out dimen-
sions on page 7.
Refer to the installation instructions
shipped with each Wolf product for detailed
specifications.
This cooktop is intended for indoor use only.
