FM Operation
•
Press the “Mode” Button to switch to FM. Press “Enter” to confirm the setting. Long-press
Tune - or Tune + to start scanning. Stop scanning when clear signal is received.
•
Manual search by short pressing Tune - or Tune +.
•
To review the station information, press if RDS message is available from the service
provider.
•
To save and listen to your favorite stations, refer to the steps of DAB+ preset stations as
mentioned above.
•
Short press Enter key, Audio mode selected to Mono / Auto, it is only for FM mode.
Bass Boost
•
To enhance the bass performance, press Enter, “Bass” is shown on the display. To
deactivate the bass Boost fun
ction, press Enter again until “Bass” disappear from the
screen.
Aux - in Jack
•
Press the "Mode" button to select AUX. Press "Enter" to confirm. To connect audio devices,
plug a 3.5mm cable into the AUX port of the hearing protection. Plug the other end of the
cable into the external audio device and start the playback.
Adjusting the fit
1.
Put on the earmuffs with the controls panel over your right ear.
2.
With the headband over the crown of your head, position the muffs to completely enclose
your ears. The muffs only provide hearing protection when worn with the headband over the
crown of your head.
3.
Slide the muffs carefully up or down to adjust for a firm, comfortable fit.
4. Ensure the cushions seal tightly against your head with no interference from foreign objects
between the ear cup and your head (such as pencils or glasses temple arms). Spread the
ear cups only enough to clear the ears. Do not return or reshape the headband.
Factory reset
•
All preset stations and other settings will be deleted.
•
Press and hold the Menu button, press Tune - or Tune
+ to find ’System Reset’. Press
Enter.
Software version
•
Press Menu and then press Tune -
or Tune + to find ’Software version’. Write it down here:
.
Storage
•
Do not store the hearing protector at temperatures exc55°C, for example on a
dashboard or windowsill. Do not store the hearing protector at temperature below -20°C.
Under extremely cold conditions, warm the hearing protector before using.
Safety instructions
•
This hearing protection is designed to protect your hearing from hazard noise.
•
Check at regular intervals that the product is undamaged and working properly. Worn or
damaged earmuffs can result in inferior protection. If the cups are cracked, if the seals are
worn or defective, or if they have been exposed to chemicals, they should be discarded and
replaced. The earmuffs, especially the sealing rings, can deteriorate over time and should
always be examined before use to make sure they are not cracked or admit noise.
•
Attaching hygienic protection on the pads can affect the acoustic properties of the cups.
•
Failure to follow these instructions will seriously reduce the protection provided by the
earmuffs.