Wolf Garten Robo Scooter 1800, Original Operating Instructions

Page: 77 / 362

18
3.3.6 Main Zone Area
If a Sub-Zone exists. Do not include it in the area size required here.
You will be promoted to define it later.
3.3.7 Test Wire Position
Testing Wire...
The unit follows the wire around the edge to test the wire position.
P
Walk along the side of the unit while it is following the edge.
Having completed the process. The unit enters the Base Station,
drives back and stops in front of the Base Station. The following
message is displayed:
Special Cases:
If an Adjust Wire message is displayed. The mower stops and
drives backward.
P
Move the wire slightly inward.
P
Press to repeat the Wire Test.
If, at any point, you wish to move the mower outward to enlarge the
covered area, press
Stop .
The mower stops and display the message:
P
Do not respond yet.
P
Move the wire slightly outward.
P
Place the mower in front of the changed Section of wire.
3.3.8 Add Another Sub-Zone
Once the Wire Test has been completed, you will be asked if you
have a Sub-Zone.
If you don’t have a Sub-Zone:
3.3.8
Press to quit the set-up process.
Scroll to select approximate area of the Main
Zone.
Press .
Press to continue the Test Wire Position.
77
en