Page 149
What is in the AMP2-16V for Dante
The Audinate Brooklyn II board automatically recognizes Dante networks when
installed, will alert other devices of its presence and configuration, and will
configure its AoIP address per DHCP or local link protocols. DHCP works best and is
recommended. There is no need to set a static address for the AMP2-16V Dante
port, so no address entry method is provided in the AMP2-16V for Dante network
setup. While possible to “Manually Configure an IP Address” from the network, this
is not recommended Dante practice and as such is not a normally tested
configuration.
Figure A-3: IP Address Configuration
Leave at the
Default Setting
Up to sixteen AoIP receive channels can be monitored at once in the AMP2-16V.
The AMP2-16V Dante AoIP is configured by the AMP2-16V to receive up to
16 channels of Dante AoIP at a 48kHz audio sample rate. 48 kHz is the
AMP2-16V default rate.
Sample rate selection is left up to the Dante Controller device or software. All
devices connected to each other through a Dante network must be set to
the same sample rate. Slight ticking may be heard in the AMP2-16V monitor
when monitoring different input types at different sample rates or if sources are
asynchronous.
