Manual_S5_Airplus_2015_04_20
Page 10 / 68
©
Wodtke GmbH - Tübingen. All Rights and Changes Reserved.Printed 04/2015
Part No. 950 976
5
Transport / Unpacking / In-
spection
The goods must be inspected for recognisable
damage and/or missing quantities immediately
upon delivery. Complaints of any type must be
acknowledged in writing by the delivering freight
forwarder and immediately reported to
wodtke
.
Transport damages which are only recognisable
after unpacking must be reported in writing to
wodtke
no later than 7 days after delivery.
Delayed complaints cannot be considered due to
insurance reasons.
Attention
: The furnace is heavy (weighs approx.
150 kg). Inspect floor beforehand for suitability for
transport and installation. The pallet may only be
transported absolutely horizontally and only by
forklift or lift truck.
Fig. 2: Transport lock
Attention: Never manually unload / transport the
pallet from the vehicle.
For manual transport, always first release furnace
from the pallet. Proceed carefully and ensure that
the feet of the furnace do not fall between the
boards of the pallet, as the feet can be broken off.
The transport lock bolts are located under-
neath the pallet.
These transport lock bolts must
be released to lift the furnace from the pallet.
Always position hand cart or the like in front on the
door side, because the centre of gravity is here.
When transporting the furnace (e.g. by hand
card), always ensure that the surfaces are pro-
tected against scratching.
Place Styrofoam or
the like between the furnace and the hand cart so
that the paint is not damaged during transport.
Recommendation:
Remove
covers
before
transport!
To release the furnace, re-
move the transport lock
bolts on the underside of
the pallet.
Take note of
the feet when
raising the fur-
nace. Do not
tilt / break the
feet.
Adjust feet to
25 mm floor
clearance at
the final instal-
lation location.
25 mm
Place Styrofoam etc. in between!
