9
TO ROLL TRACTOR OFF SKID (See
Op er a tion section for location and
function of con trols)
1. Press lift lever plunger and raise
attachment lift lever to its highest po-
si tion.
2. Release parking brake by de press ing
clutch/brake ped al.
3. Place freewheel control in “trans-
mis sion disengaged” position (See “TO
TRANS PORT” in the Op er a tion section
of this manual).
Seat pan
Label
Terminal
Terminal
CHECK BATTERY
1. Lift seat pan to raised position.
NOTE:
If this battery is put into service
after month and year indicated on label
(label located between terminals) charge
battery for minimum of one hour at 6-10
amps. (See "BATTERY" in Maintenance
section of this manual for charging instruc-
tions).
7. Slide seat until a comfortable position
is reached which allows you to press
clutch/brake pedal all the way down.
8. Get off seat without moving its ad-
just ed position.
9. Raise seat and tighten adjustment
knob securely.
02466
Seat Pan
Shoulder
Bolt
Adjustment Knob
Flat Washer
Seat
02464
NOTE:
You may now roll or drive your
tractor off the skid. Follow the appropriate
instruction below to remove the tractor
from the skid.
IMPORTANT:
For shipping purposes, the
mulcher plate was preattached to your
mower. The mulcher plate must only be
used with the mulching blades that came
packed separately in the carton.
Your mower came factory equipped with
high performance blades, which are the
best blades for bagging and dis charg ing.
To use your mower with the high per for -
mance blades the mulcher plate must be
removed from the mower.
TO SET UP YOUR MOWER FOR
MULCH ING
• Remove high performance blades and
install mulching blades, (see BLADE
RE MOV AL in the Maintenance sec tion
of this manual).
4. Roll tractor forward off skid.
5. Remove banding holding defl ector
shield up against tractor.
TO DRIVE TRAC TOR OFF SKID (See
Op er a tion section for location and
function of con trols)
WARNING:
Before start ing, read, un-
der stand and fol low all in struc tions in the
Op er a tion section of this man u al. Be sure
tractor is in a well-ventilated area. Be sure
the area in front of tractor is clear of other
peo ple and objects.
1. Be sure all the above assembly steps
have been completed.
2. Check engine oil level and fi ll fuel tank
with gasoline.
3. Place freewheel control in "trans-
mis sion engaged" position. (See “TO
TRANS PORT” in the Op er a tion section
of this manual).
4. Sit on seat in operating position,
depress clutch/brake pedal and set the
parking brake.
5. Place motion control lever in neutral
(N) position.
6. Press lift lever plunger and raise
attachment lift lever to its highest posi-
tion.
7. Start the engine. After engine has
started, move throttle control to idle
position.
8. Release parking brake.
9. Slowly move the mo tion control lever
for ward and slowly drive tractor off
skid.
10. Apply brake to stop trac tor, set park ing
brake and place motion con trol lever in
neutral po si tion.
11. Turn ignition key to "STOP" position.
Continue with the in struc tions that follow.
For Parts Call K&T 606-678-9623 or 606-561-4983
www.mymowerparts.com