\Handouts\CMCConvertibleStand
02/15/08
--
Wizard™ International, Inc., 4600 116th St. SW, PO Box 66, Mukilteo, WA 98275 888/855-3335 Fax: 425/551-4350
wizardint.com
Placing the Wizard CMC onto the Convertible Stand
The Wizard CMC is now ready to mount onto the Convertible Stand. Get another person to help, and
place the Wizard CMC onto the Stand (Fig A-C). Make sure the bottom edge of the Wizard CMC is
seated against the Board Stops/Extenders.
Fig A.
Fig B.
Fig C.
Fig A: Angled Stand. Fig B: Upright Stand. Fig C: Upright Stand with Board Stops for the 8500e.
Look at the back of the Wizard CMC and make sure that you avoid pinching the airlines on the back,
and that none of the threaded washers are touching the Stand (Fig D). Position it side to side wherever
you’d like it to be; the right end of the machine can be within 4” of a wall if necessary.
Screw a screw into the hole in the Board Stop/Extender and into the Board, and secure into place
(Fig E).
Place the Driver Pak into the Driver Pak Basket (Fig F). Hook up the pneumatic and electrical con-
nections. You have now installed your Wizard CMC onto the Convertible Stand.
Fig D.
Fig E.
Fig F.
Fig D: Don’t pinch airlines or threaded washers on the stand. Fig E: Screw a screw into the Board Stop/Extender into
the Board to secure it into place. Fig F: Place the Driver Pak into the basket.