Before starting installation work:
Only properly trained personnel may carry
out work, or be allowed access to the
installation site.
-
Attach safety devices to guard against falling
(platform or harnesses)
-
Cover any floor openings
-
Secure installation tools or objects against
accidental falling
-
Lift shaft openings should be cordoned off
and suitable warning signs should be erected
when working in shaft openings
-
Work involving electrical equipment should
only be carried out by an electrical engineer or
qualified personnel.
1.4
Preparation
Before beginning installation work it is in your
own interest to ascertain the constructional and
spatial conditions. Where (workshop or on site)
and when which installation operations can or
must be carried out. It is therefore recommended
to take all the given circumstances into account
and to plan the various operational sequences in
advance, rather than carrying them out prema-
turely and in an unconsidered manner.
On the receipt of the delivery, the goods or com-
ponents should be checked for correctness and
completeness with the order sheet.
The following should be checked also:
-
the factory and order number must correspond
-
the details on the name plate must correspond
to those on the order
-
the elevator speed
-
the width and type of guide rail used
-
the total load (mass to be gripped)
1.5
Advice for when working on
safety components
Safety gears are classified as safety components. It
is most important that the standards and guide-
lines described in this section are complied with as
well as those given in the rest of this operating
manual.
These instructions, and especially the sec-
tion on safety precautions, should be read
and fully understood before work begins.
Safety devices require special attention. It is com-
pulsory that they function perfectly to ensure
danger free installation operation.
Safety devices that can only be adjusted after
installation should be done so immediately after
installation.
Operation of safety devices installed ex-works
must be tested immediately.
If it is necessary to disassemble a safety device
during servicing or repair, they should be reassem-
bled and checked with the required tests, as soon
as the work has been carried out.
Progressive Type Safety Gear
CSGB-01 / 02
Operating instructions
Änderungen vorbehalten!
Subject to change without notice!
Blatt/
ëÜÉÉí
PM.7.002505.EN.005
Datum/
Ç~íÉ
26.07.2012
Stand/
îÉêëáçå
26.07.2012
Geprüft/
~ééêçîÉÇ
WAT/MZE
© WITTUR – All rights reserved
