Safety
V.. / NV.. / CV..
en-4
2022-D059517
Revision: 05
2
Safety
These instructions, especially the safety and warning notices and the rules and regulations valid for
the operating site, must be observed by all persons working with the gearbox.
The following, especially, must be strictly adhered to:
Observe the instructions for transport and storage.
Use the gearbox only in accordance with its intended use.
Carry out maintenance and repair work appropriately and professionally in conformity with the
specified intervals.
Always mount, dismantle, and operate the gearbox properly (e.g. even test run only with
secure mounting).
The manufacturer of the higher-level machine shall, in accordance with its risk assessment,
install protective devices and equipment as appropriate to protect the user from the residual
hazards of the gearbox. Only operate the gearbox with intact and active protective devices
and equipment.
Only operate the gearbox with the correct lubricant (type and amount).
Prevent the gearbox from becoming extremely soiled.
Only carry out modifications or reconstructions when these are approved in writing by the
WITTENSTEIN alpha GmbH
.
Personal injuries or material damage, or other claims arising from non-observance of these
minimum requirements, are the sole responsibility of the operator.
In addition to the safety-related information in this manual, also observe any legal and otherwise
applicable rules and regulations, particularly for accident prevention (e.g. personal safety
equipment) and environmental protection.
2.1
EC/EU Directive
2.1.1 Machinery Directive
The gearbox is considered a "machine component" and is therefore not subject to the EC
Machinery Directive 2006/42/EC.
Startup is prohibited within the scope of the EC directive until it has been determined that the
machine in which this gearbox is installed corresponds to the regulations within this directive.
2.2
Personnel
Only technicians who have read and understood this operating manual may perform work on the
gearbox. Based on their training and experience, technicians must be able to evaluate the tasks
assigned to them, in order to recognize and avoid risks.
2.3
Intended use
The gearbox serves to convert torques and speeds. It is suitable for all industrial applications.
The gearbox may not be operated in areas with potentially explosive atmosphere.
In food processing / pharmaceutical / cosmetics, the gearbox may only be used next to or under the
product area. Product-specific deviation regarding the positioning and mounting position are
described in Chapter 3 "Description of the gearbox".
The gearbox has been constructed according to current technological standards and accepted
safety regulations.
To avoid danger to the operator or damage to the machine, apply the gearbox only for its
intended use and in a technically flawless and safe state.
If you notice any altered operating behavior, check the gearbox in accordance with Chapter 8
"Malfunctions".
Read the general safety instructions before beginning to work (see Chapter 2.5 "General
safety instructions").
