Assembly of the 3-Gang Picker
1. Remove nylon lock nuts and washers from
mounted studs on front section.
2. Place Swivel and caster fork over mounted
studs on front picker section.
Mounting the push bar (H-Bar):
1. Remove the two connecting rods from the
push bar.
2. Align the mounting sleeves on the end of the
push bar with the corresponding mounting
sleeves on the back of the drawbar.
3. Insert the connecting rods through the
sleeves and replace retaining pins.
Assemble the picker on level ground.
4
Installing Swivel and Caster fork (if not already installed):
3. Replace and secure lock nuts and washers.
Installing the front picker sections:
1. Mount the front of the drawbar to ball hitch
as with conventional trailer mount.
2. Tighten the coupler all the way then loosen
¼ turn.
Installing the rear picker sections:
1. Remove retaining pin and 5½” assembly pin
from post assembly bracket (the pin that is
mounted horizontally on post assembly bracket).
2. Insert mounting sleeve (on frame) in between
post assembly bracket.
3. Insert assembly pin through post assembly
bracket and mounting sleeve.
4. Replace retaining pin.
5. Remove shaft collar and retaining pin on the
vertical rod of the post assembly bracket.
6. Insert post assembly arm upward through
sleeve of drawbar.
7. Replace shaft collar and retaining pin.
Place the picker baskets into the picker assembly.
Summary of Contents for Range Rover 3 Gang
Page 2: ...3 Gang 5 Gang 2...
