HEATING ELEMENT REPLACEMENT
1. DISCONNECT THE CABINET FROM ITS POWER SOURCE.
2. Open the door to the cabinet.
3. Remove the bottom mounted element cover.
4 Remove the retaining screws securing the element to the interior rear of the cabinet.
5. Gently pull the element from is housing until the electrical lead wire connectors are exposed.
6. Disconnect the defective element at the electrical lead wire connectors.
7. Connect the element lead wires to the cabinet lead wires by reinstalling the wire connectors.
8. Tuck the residual wire back through the wire housing hole until the replacement element is against the interior
rear wall.
9. Reinstall the element retaining screws.
10. Reinstall the protective element cover.
11. Reconnect the cabinet to the power source and test.
THERMOMETER REPLACEMENT
1. DISCONNECT THE CABINET FROM ITS POWER SOURCE.
2. Remove the top cover by removing the retaining screws and lifting the top cover off the cabinet to expose the
thermometer.
3. Identify and remove the thermometer sensing bulb screws and retaining clips located in the interior top of the
cabinet. Pull the thermometer sensing bulb through the access hole located in the top of the cabinet.
4. Remove the retaining nuts which secure the thermometer to the housing located on the back of the control panel.
5 Remove the thermometer by pushing it from the rear through the control panel.
6. Install the replacement thermometer following the reverse of the above procedure.
7. Reconnect the cabinet to its power source and test.