Witt SmartSousVide, Manual

Page: 8 / 12

8
GETTING STARTED
• Clean the device outer surface with a soft damp cloth before the first use.
• Place a cooking pot, a plastic or another suitable heat resistant container on a flat, stable and heat
resistant surface. Fasten the device support on the side of the pot or container.
• Connect the plug to a wall socket. Important! Make sure that your household voltage is no more
than 240V! Otherwise your device may be damaged.
• Fill the pot with lukewarm tap water. In this regard, pay attention to the Minimum and Maximum
indicators on the front of the appliance. The water level should be precisely between the two indicators.
• Place the vacuum sealer bag containing the food into the device. Ensure that the water level does not
go over the MAX marking. Ensure that the bags are always surrounded by water.
Attention:
The water evaporates through the heating process. If the water level falls below the MIN marking, a
permanent alert will sound. The warning symbol and the stop symbol appear in the display and the
heater will turn off immediately. In this case add water and start the appliance once again.
• Slide the red switch on the back of the instrument to the position „ON“.
• The red switch lights up.
• All segments will be displayed briefly.
• The icon NOW, the thermometer symbol and the current temperature appear at the top part of the display; on
the bottom part appear the icon TARGET, the thermometer symbol and the temperature (70,0°C default) flash.
SELECT COOKING MODE
Simple cooking
• Press the – or + button to set the desired target temperature.
• Press the START/STOP button to start the cooking process.
• The instrument turns on and a circular symbol will appear in the middle of the display. The water begins
to circulate and to heat.
• When the exact target temperature is reached, the target symbol appears on the display.
Cooking with time duration
• Press the SET button. The timer symbol appears on the display.
• The thermometer symbol and 70,0°C (default) flash. Press the – or + button to set the
desired target temperature.
• Press the START/STOP button to confirm.
• The timer symbol and 0:05 min. (default) flash. Press the – or + button to set the desired time duration
for the cooking process in steps of 5 minutes each.
• Press the START/STOP button to confirm.
• Press the START/STOP button again to start the cooking process with the desired time duration.
• The instrument turns on and the circular symbol appears in the middle of the display. The cooking
process begins.
• After the cooking is finished, an alarm sounds and the stop symbol appears. The device will turn off the
heater automatically.
Cooking time programming (with timer delay)
• Press and hold the SET button for two seconds. The timer and the clock symbols appear.
• The thermometer symbol and 70,0°C (default) flash. Press the – or + button to set the desired target
temperature.
• Press the START/STOP button to confirm.