2
1.2 To be considered before initial operation
-
Check that the device has not been damaged in transit.
-
Push cannula on tightly.
-
Do not carry the device at the outer housing (2).
-
Push ejection cannula (6) on tightly and slide the cannula holder (7)
into the formed grooves.
-
When screwing on the bottle do not grip the device at its outer
housing (2).
-
Do not pump before the device has been assembled completely and
a collecting vessel has been placed underneath.
1.3 Warranty
witeg warrantees the
Labmax
you have received is free of defects in material
and workmanship for 12 months from the date of purchase. witeg´s
responsibility is limited to the repair or replacement of the
Labmax
.
This warranty is valid only if the
Labmax
is used in the manner described in this
manual and for the purpose for which it is designed.
witeg is not responsible for consequential damages resulting from the misuse of
this equipment.
1.4 Operating limitations
Labmax “OE”
Labmax “OE S”
Labmax “OE HF”
Use for
nearly all liquids
PTFE swelling
solvents
hydrofluoric acid
PTFE swelling
Solvents,
hydrofluoric acid
hydrofluoric acid
PTFE swelling
solvents
solutions which contains any form of solids
Don´t use for
solutions of substances catalysed by platinum-iridium alloys
The temperature of the
Labmax “OE”
and reagent should not exceed 40 °C
(104 °F).
3
21
20
2 General product description
The
Labmax “OE”
is witeg´s economy dispenser and consists of high precision
components and extreme solid materials “made in Germany”. This ensures
highest reproducibility during the complete long life cycle of the device.
The
Labmax “OE”
is fully autoclavable at 121 °C and can be completely
disassembled for cleaning. The zero point is part of the construction and
automatically calibrated after assembling.
Each device is single tested and delivered with conformity certificate.
The air-purging is managed through the ejection cannula and therefore no air
bubbles get into the bottle and a contamination of the bottles content with
previous used chemicals is not possible.
The
Labmax “OE”
has the witeg´s typical Safety-Lock for your safety at work.
Turn the cannula 180 ° to drain it and avoid further uncontrolled flow of liquid.
3 Preparations
First push the ejection cannula into the
valve and then slide the cannula holder
from above into the groove. Make sure it
fits tightly!
Push the return tube (21) into the big socket and the suction
tube (20) into the small socket.
Control the length of the suction tube and make sure it fits
tightly!
Now you can screw the
Labmax “OE”
onto the bottle.
((20) and (21) are one tube at the
Labmax “OE“ 250 ml
)
