24
9 Electrical connection
Warning: Risk of death!
Incorrect installation and electrical connection can pose a fatal risk.
Prevent hazards arising from electrical energy.
-
Only have installation and electrical connection performed by a
specialist and in line with the valid regulations
(e.g. IEC, VDE, etc.)!
-
The current type and voltage must correspond with the
information on the type plate.
-
Observe the specifications of local energy supplier!
-
Observe accident prevention regulations!
-
Never pull on the power cable
-
Do not bend the cable
-
Do not place any objects on the cable
-
When using the pump in systems at temperatures over 90 °C, use a
connection line that is suitably heat resistant.
-
Hazards such as sharp edges and burrs arise during installation.
-
When transporting the pump, never hold it by the power cable.
-
The pump could cause an injury if it falls.
Connect the power cable to the pump as shown.
Caution: Line voltage!
Observe the required protective
measures, national body regulations and local provisions
at all times. The cable cross-section may no smaller than
0.75 mm². Use ferrules if using fine-wire cables.
9.1 Assembling the power plug
(optional
)
