MTP51-JP User Manual
9
<INFO> menu
This menu can be entered by scrolling selector.
In this menu it’s possible to see FW version/HW version/Serial
Number/Bandwidth/Bootloader version/Option
<IRDA>
While there is this menu, the device can be connected to IRDA for
setup or firmware upgrades.
Note: if the IRDA interface is enabled and there’s no communication for around 10 seconds, the IRDA
interface is automatically turned off.
During power on the device, the IRDA interface is enabled for 14 seconds. Thanks to this feature it
is possible to connect the transmitter to the Manager for upgrade/configuration or do a SYNC with
Wisycom receiver without enter manually on the menu.
<LOCK>
Long pressing (2 sec.) selector button (
click
) it locks MTP51-JP in
transmission mode.
To unlock, long pressing (2 sec.) selector button again.
<BOOTLOAD>
This menu can be entered by turning on the transmitter while pushing
at the same time
both quick
channel setup buttons (<
ch
> &
<gain>
) or connecting the device via
IRDA using the IR Programmer for FW update
Device is forced in bootloader mode to allow
FIRMWARE UPDATE
.
MIC Mode setting:
MIC Mode:
Pin out
Gain
PTT
Led Mode
’2 wires’:
1=GND
3=AF
-60/40 dB
Disable
Normal
Muting
No data
None
Mod. Peak
PTT
‘2 wires + bias’:
1=GND
3=AF+5.5V
-60/40 dB
Disable
Normal
Muting
No data
None
Mod. peak
PTT
‘3 wires’:
1=GND
2=5.5V
3=AF
-60/40 dB
Disable
No data
None
Mod. peak
3 PIN LEMO CONNECTOR
(use FVB.00.003.NLN on Mic)
