- 12 -
13.3.3 Insert cable back into bolt A, slot cable guide pipe into holder and fit
protector over guide pipe end. Set cable in bolt A so that the combined
pad/rim clearance (the gaps from left pad to left rim surface and from
right pad to right rim surface) is 2mm, then tighten bolt A. Finally
tightening it to 6-8N.M.
Balance brake arms with screw D. Depress brake lever a few times while
Checking to see that tension is equal for both arms. Pad/rim contact
should occur at the same time each side. Clearance should be 1mm each
side.
13.3.4. Adjust pads so they are properly aligned (see step 2), as tension
adjustment will probably have altered original pad alignment.
Warning: If you are unsure about any part of the installation process you should seek
advice from Wisper service center or qualified mechanic.
14 Stem handle bar clamp
14.1
Your bike has been fitted with a quick release handlebar clamp that allows you
to change the position of the bars quickly and easily to find the most
comfortable riding position.
14.2
The stem and handle bars need to be fitted before you use the bike.
14.3
To fit, insert the stem into the front tube at least to the position of the
“Minimum insertion” mark.
14.4
Tighten the quill bolt and fix stem.
14.5
Push in the direction of the arrow slide cap 1 and lift lever 2.
14.6
Adjust stem to preferred angle and lightly tighten BOLT 1 then turn BOLT 2
to suitable position so that the slide cap 1 will fit when locked, then press down
lever 2 to lock the handle bars in position.
14.7
Test the bars to make certain they are tight and do not rotate. If they are not
tight enough, lift lever 2, adjust BOLT 2 again then press down lever 2. Repeat
until the handle bars are tight and safe.