Installation
Instruction Manual WISKA
Edition 1.6
–
09/2020
15
Article-No.:
300
78457001
To install the units, drill the required holes and make openings if required, as shown in chapter
3.4
Dimensions
.
Make sure to provide wires of sufficient size (cross-section) for the cable length.
4.3
Electrical connections
Danger of electrical shock!
Electrical connections may only be completed
by qualified personal. Be sure the power cord is dead and nobody can
accidentally resume the power supply during installation!
The circuit diagram is enclosed separately, or you find it in chapter 3.5
Diagram
.
Connected load values
Supply voltage: 230 VAC, 50/60 Hz.
Unit Fuses: 1 x 6 A,1 x 16 A, 1 x 60 A included,
for SX450/1600: 1 x 6 A,1 x 16 A, 1 x 100 A.
(Also 2 spare fuses 60A or 100A are shipped with the unit.)
Waterproof (IP56) installation of all cables
1. Unscrew the cover on the underside of the PSUX power supply unit and
remove it.
2. Drill holes matching the cable size and insert cable fittings into holes.
3. Feed the cable through the cable fittings and fasten firmly.
4. Be sure to use the appropriate wire size for current and distance!
Attention!
To ensure IP56 protection class:
The unit sheathing must have a waterproof seal: pull the fittings firmly
into place so that the seals are wrapped tightly around the cable fitting!
4. Connect cables in accordance with the circuit diagram (see separate
circuit diagram or chapter 3.5
Circuit diagram
).
Note:
The cable from the searchlight and FL52 drive unit can be
connected directly to the power supply unit (PSUX) or via an optional
junction box.
Power supply
•
Be sure to observe any applicable international or local country
regulations! Connect to the power supply while ensuring reverse polarity
protection!
Before first use:
•
Check that installation has been carried out correctly. Reverse polarity
will destroy the Xenon lamp.
•
Check to be sure that grounding and zero current works properly!
•
Reinsert fuses.