12
· English
Mounting the SmartCam d1
disassembling
1.
Use a screwdriver to remove your existing doorbell.
Disconnect the wires from behind the doorbell
carefully.
Install on the wall
J
`
Check whether or not the camera installation position is suitable for good video
reception.
1.
Mark the position of the mounting holes for your
new doorbell.
2.
Drill the holes about 1.2 inches deep into the wall.
(Recommended Drill Bit size is 0.2 inches)
J
`
It is recommended to use a drill bit (Ø5) that is suitable
for the wall material.
`
Be careful not to get injured while drilling.
3.
Unscrew one of the power terminals on the back of your
SmartCam D1, and wrap the existing wiring from your
doorbell around the terminal, and then tighten the screw.
n
`
It doesn't matter which cable you use on which side of the
terminal back.
4.
Optional Step for Extending Power Supply (Requires
Power Extension Kit):
4-1
If existing wire is too short, use the Power Cable
Extender and connect the flat circular end of it to
the terminal, then screw the terminal back on.
4-2
Pull the orange levers on the terminal blocks up.
4-3
Insert the existing cable from the wall to one of
the slots and push the orange lever back down.
4-4
Insert the new power cable from the doorbell to the other slot and pull
the lever back down in place.
4-5
Repeat this process for the other side.
5.
Mount the SmartCam D1 on the wall.
5-1
Insert the anchors into the holes
completely.
5-2
Tuck the wires attached to the
doorbell back into the wall and
align the two holes on the doorbell
with the holes in the wall.
5-3
Screw the SmartCam D1 tightly
into the wall.
n
`
Make sure to remove the faceplate attached to your SmartCam D1 to access the
mounting holes.
RESET
RESET
RESET
