11
02
Installation & Network Connection
6.
Repeat Step 5 for the [
trans
] cable.
7.
Put the chime cover back on once you are
finished.
n
`
Make sure to tuck the cables and Power Stabilizer
box into an open space within the chime before
putting the cover back on.
4.
Use a screwdriver to loosen the screws
on the [
FRont
] and [
tRanS
] terminals
and then remove the cables.
n
`
Make sure to label the terminal cables
before disconnecting them. You will need
to connect them to the terminal blocks
later.
5.
Connect Power Stabilizer to Chime
5-1
Pull up the orange levers on the terminal block.
5-2
Insert the Power Stabilizer cable into one of the slots
and push the orange lever back down.
5-3
Insert the wire labeled “Front”
into the remaining opening of
the terminal block.
5-4
Insert the Power Stabilizer
cable into one of the slots and
push the orange lever back
down.
n
`
Make sure the end of the wire is
properly aligned to the metal strip
before closing the orange lever.
FRONT
TRANS
REAR
FRONT
TRANS
REAR
FRONT
TRA
NS
REA
R
