Wisdom SC-2, Owner'S Manual

Page: 19 / 23

19
•
The correct wiring for converting Balanced to Single Ended for the output of the
SC-2 is shown below.
CAUTION! Note that a Balanced to Single Ended adapter for use on the output
side of the SC-2 is different than the appropriate adapter on the input side. Should
you need them, properly wired adapters are available from Wisdom Audio for a
nominal charge
However, as mentioned previously we recommend using our pre-made Custom
Interconnect Kits (
WWK-CUSTOM2 and or WWK-CUSTOM3 ) for the best in audio
performance and reliability.
Configuring your SC-2 and Preparing for Calibration
Prior to setting up your SC-2 please we recommend watching the System Controller
Configuration Tutorials found on our
YouTube Channel
https://www.youtube.com/watch?v=wjIpZngnJR0
Locating the SC on your network:
1. Device is configured via Ethernet/IP/HTML. Ensure Device is connected to
LAN.
2. The device should always be discoverable at first startup by entering
http://SC2.local/wizard.html# into the address bar (This is the same log-on for
both the SC-2 & SC-3, unless your unit has been upgraded to the new firmware
then it is simply:
http://SC.local/wizard.html# ) of your web browser (Google
Chrome works best).
3. If you cannot locate the device. The backdoor is to locate its IP address and
access it directly. This can be done by IP search wizards such as Angry IP
Scanner. Look for the MAC Vendor named “IEEE”. The MAC address should
start off with Momentum Data System’s Mac Vendor ID: 70:B3:D5:E4:5X:XX
4. Once the IP address has been discovered use it to access the device, do not
forget to add /wizard.html# to be taken to the Configuration Page. Example
http://192.168.1.10/wizard.html#
System Calibration
We recommend you contact your dealer, or regional Wisdom Audio representative
about purchasing a Factory Calibration & Room Commissioning (2 month
advanced noticed is required).