37
Equipment Info
This information will be included on the certificate that is available from the in-
staller section of the Audyssey web site.
Measurement
The Measurement screen is where MultEQ
®
Pro collects the data it requires for
accurate room correction. At this point, your installer will connect an XLR cable
between the microphone preamplifier LINE OUT connector and the Left input
of the SC-1 (the top-left corner as seen from behind).
The mic preamp should be placed as close to the microphone as possible (e.g.,
the shortest cable length). Use any additional XLR cables between the mic
preamp and the SC-1, where they will carry the line level signal.
Microphone position
Place the microphone in a vertical position with the capsule pointing directly at
the ceiling for all room measurements. Make sure there are no nearby obstruc-
tions or large reflecting surfaces.
(artwork courtesy of Audyssey Laboratories™)
The Measurement screen includes a help section of scrolling text to provide
more details. (See below.) Some important notes:
• The microphone should be positioned as far out from the stand
as possible to minimize the effect of stand reflections. The micro-
