O p e r a t i n g M a n u a l
OKTOPUS
®
GLASS-Jack
GL-N 400/300
Technical Documentation
BA 000 180_OA
Page 17 of 22
⇒
Release unlocking “Tilt” (see fig. 8) and position the load horizontally.
Fig. 10:
OKTOPUS
®
GLASS-Jack GL-N 400/300 during tilting
3.6 Mounting the extension arms
⇒
Place the OKTOPUS
®
GLASS-Jack GL-N 400/300 flat on a clean and even surface
(suction pads facing the floor).
⇒
Perform the following steps one after another for each extension arm to be attached:
- Demount a suction pad from the suction frame. Therefore remove the lynch pin as
well as the corresponding locking bolt.
- Slide an extension arm into the base frame and fasten it with a locking bolt that is
provided in the delivery. Secure the locking bolt with a lynch pin that is also provided
in the delivery.
- Mount the suction pad that was removed beforehand to the extension arm using the
locking bolt that was removed beforehand. Secure the locking bolt with a lynch pin.
Demounting
the extension arm is done in reverse order.
Fig. 11:
Mounting the extension arms
Make sure that the locking bolts are always completely secured with the
lynch pins provided by the manufacturer!
Glass element
Locking bolt with
lynch pin
Locking bolt with
lynchpin
Extension arm
Suction pad
