INSTALLATION INSTRUCTIONS
The Apple iPad is a high value tablet computer, and as such, proper installation is
paramount in ensuring it is secure once installed in the IPAD2THRM. Failure to comply
with these instructions may result in damage to your iPad.
1. Remove the 2-piece iPad mounting bracket from the box.
2. Connect the hinged adjustable bracket to the iPad bracket by aligning the four clips
and sliding towards the ‘closed’ position. The four clips should engage with a solid
‘click’. Once assembled, the text on the rear of the bracket should be upright.
NOTE: If the bracket is upside down, the iPad may be easily knocked out
of bracket and fall, causing damage. Damage to the iPad is not, under any
condition, covered by the Wirez Warranty.
3. Loosen (but do not remove) the two thumb screws on the horizontal portion of the
bracket and position the retaining clips such that they roughly 1 inch wider than the
headrest posts.
4. Place the bracket against the posts and slide the retaining clips over the posts.
OVERVIEW
Congratulations on your purchase of the Wirez IPAD2THRM iPad Headrest Mounting
kit. This kit was designed to quickly and easily allow you to transform your iPad into a
rear seat entertainment system.
The kit includes:
1
Multi-Adjustable iPad Mounting Bracket
1
6’/1.8M USB to Apple Dock Connector Cable
1
6’/1.8M Auxiliary Input Audio Cable
1
Dual USB Power Adapter Charger
1 Owner’s
Manual
INSTALLATION NOTES
• The IPAD2THRM is NOT compatible with the 1st Genertation iPad.
• The IPAD2THRM is not designed to be used with any iPad when installed in a
protective case.
• The IPAD2THRM was designed to attach to the headrest posts found in most
vehicles.
• The bracket will connect to posts with center-line spacing between 2.5 and 8
inches.
• The Dual USB Charging Adapter is designed for use on standard 12V automotive
electrical systems that use a negative ground.
