© 2018 Wireless Prime INC. All Rights Reserved.
Precautions
27
a. Do not plug in or pull out the HDMI cable of the transmitter and receiver
during normal use.
c. When the OSD prompts that code matching fails after trying code matching,
reboot the transmitter and receiver to see whether they can be connected
normally. Perform code matching again when it is still unable to be
connected after restarting.
d. When there is no video source output since a blank screen appears during
the receiver output after switching the video source resolution, pull out
and then plug in the HDMI cable of the transmitter or receiver. If the HDMI
cable cannot be recovered after removal and insertion, power off and
restart the transmitter and receiver.
e. When the network cannot be connected for a long time after switching
frequency channel, reboot the transmitter and receiver.
f. When the transmitter and receiver devices are connected normally,
there is no output on the monitor at the receiver, or the video output is
abnormal, re-plug the HDMI cable of the receiver and check whether the
monitor is on standby. If it is still unable to output normally after the above
operation, try to replace the display device.
2. If there is a picture jam or mosaic during use, it is generally caused by
interference in the network. Therefore, try switching the network frequency
channel to avoid the interference band. The frequency
switching
operation refers to the frequency
switching operation instructions.
channel
channel
b. Connect the transmitter to the video source and connect receiver to
a monitor via HDMI and then power on the transmitter and receiver.
1. If transmitter or and receiver use HDMI cable a f
Precautions
