I
I
n
n
s
s
t
t
a
a
l
l
l
l
a
a
t
t
i
i
o
o
n
n
I
I
n
n
s
s
t
t
r
r
u
u
c
c
t
t
i
i
o
o
n
n
s
s
2. There will be a reduction in the data overhead on the uplink
channel – potentially saving some uplink costs.
However UDP protocol, although reliable over most links, has been
seen to be blocked by a few uplink providers' firewalls. So if you
choose to change the protocol to UDP, it is strongly recommended
that each of the uplinks is tested to make sure that all three arrows
on the 'connect' page are highlighted when you connect. This will
confirm that there is no problem with your uplink provider's firewall,
and that you can reliably use UDP as the transport protocol. Note
that this setting only applies when you are using the Wired Ocean
downlink; it has no effect when the downlink is set to 'none'.
To change the Uplink Transport Protocol:
1. Click on the “SETTINGS” tab and then the “GENERAL” tab.
2. Click on “Advanced Settings” (move the side bar up or down
until you see the contents).
3. Select TCP or UDP. The default is TCP.
Page 13
