SERVICE MANUAL & ICA
WIPLINE 3730 & 3900 FLOATS
P/N 1002551
Revision K
Page 31
1. 4:10 NHS 4 ply
2. PSI 38 lbs
6.6 TIRE SIZE
Insertion of the nose gear retractor is simply the reverse of the removal. When reinstalling the nose box, be sure
to remove all old deposits of RTV. Apply new RTV sealant between bulkheads and nose box. Note: Be sure
access hole on top of nose box is covered and sealed before installation.
6.7 INSERTION
Due the wear over time the roller/slide block places on the track as the gear are retracted, the block needs to be
measured for the amount of wear. The tolerance for wear is .050 inches. If the wear is, or is less than the limit, it
can still be used. If the wear in the track is greater than .020 inches, the block must be replaced. This check is to
be done every 200 hours.
3730 Series Floats Gear Track P/N 3A07349 (-001 LT -002 RT)
6.8 NOSE BOX TRACK WEAR