Outdoor Wi-Fi Smart Box INSTALLATION INSTRUCTIONS
!
WARNING: This timer should be installed by a licensed electrician. Turn power off at main panel before servicing this switch or the
equipment it controls.
IMPORTANT: For outdoor use. Rain-tight or wet location conduit, hubs, tubing, and cable fitings that comply with requirements
of UL 514B must be used for installation.
Read Important Safety Information below before beginning installation.
Open outer cover by releasing the spring latch.
Remove the interior protective cover by removing the two screws holding the cover in place (Figure 1).
Select the knockouts to be used. Remove the inner 1/2” knockout by inserting a screwdriver in
the slot and carefully punching the knockout loose. Remove slug. If 3/4” knockout is required,
also remove the outer ring with pliers after removing the 1/2” knockout. Smooth any rough edges
with a file or sandpaper, if necessary.
Place the Smart Box in the desired mounting location and mark the location of the mounting
keyhole. Install a screw at mark and drive partially in place. Attach Smart Box by placing keyhole
over screw; then tighten screw firmly.
Wire in accordance with national and local codes (see wiring diagrams below). Use only copper
conductors, #8 AWG wire, suitable for at least 175° F (80° C). Tighten all connections to 12in-Ibf.
Grounding: Terminate all ground wires to grounding lug at the bottom of enclosure (Figure 2).
Replace interior protective cover.
Close outer cover. Smart Box is now ready to be connected to the WiFi router via the app.
1.
2.
3.
4.
5.
6.
7.
8.
9.
Figure 1
Figure 2
!
Important Safety Information
WARNING: Risk of Fire or Electric Shock. Read instructions thoroughly before installation and preserve for future reference.
Disconnect power at circuit breaker and test that power is off before installing (or servicing) the Smart Box (more than one circuit breaker or disconnect switch may be
required to fully disconnect power).
Wiring must be in accordance with all national and local electrical code requirements. Inspect all terminals and wires with voltage meter before touching. The maximum total
load to be controlled must not exceed Smart Box capacity.
The Smart Box enclosure does not provide grounding between conduit connectors. When metallic conduit is used, you must also
install grounding type bushings and jumper wires in accordance with National Electrical Code (NEC) requirements.
