Wintriss SmartPAC 2, User Manual

Page: 283 / 604

SmartPAC 2 with WPC 2000 Integration User Manual 1128600
Program Mode 5-29
1.
On the Ready Signal Programming screen, set the Ready On angle on the crank angle
clock, using the Left (

) and Right (

) cursor keys.
As you press the Left (

) cursor key, the On cursor moves counterclockwise around the
display, and the On angle value decreases. When you press the Right (

) cursor key, the
On cursor moves clockwise around the display, and the On angle value increases.
The precise On angle value is displayed in the window inside the clock display.
2.
Set the Ready Off angle on the crank angle clock, using the Up (

) and Down (

) cursor
keys.
As you press the Up (

) cursor key, the Off cursor moves clockwise around the display,
and the Off angle increases. As you press the Down (

) cursor key, the Off cursor moves
counterclockwise around the display, and the Off angle decreases.
The precise Off angle value is displayed in the window inside the clock display.
3.
When you have finished setting the Ready On and Ready Off angles, press RESET. The
Sensor Settings screen (see Figure 5-30, page 5-30) displays with all your sensor settings
shown.
4.
If you want to change any settings, refer to
Viewing and Changing Sensor Settings
,
page 5-30).
Otherwise, press RESET to return to the Die Protection Sensor Menu. The highlight bar
automatically scrolls down to the next sensor displayed on the menu.
Setting the Counter Value for a Green Special Sensor
After you select the stop type for a Green Special sensor, the Green Special Sensor Stroke
Count screen, shown in Figure 5-29, displays. On this screen, you set the number of strokes in
the interval between required Green Special sensor actuations.
Figure 5-29. Green Special Sensor Stroke Count Screen
F1
F2
F3
F4
F5
F6
F7
F8