Wintriss SmartPAC 2, User Manual

Page: 284 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
5-30 Program Mode
To set the Green Special sensor stroke count, do the following:
1.
On the Green Special Sensor Stroke Count screen, increment or decrement the stroke
counter (maximum value is 99), using the Up (

) or Down (

) cursor key, until the value
you want is displayed.
2.
Press RESET. The Sensor Settings screen (see Figure 5-30) displays with all your sensor
settings shown.
3.
If you want to change any settings, refer to
Viewing and Changing Sensor Settings
(next
section).
Otherwise, press RESET again to return to the Die Protection Sensor Menu. The highlight
bar automatically scrolls down to the next sensor displayed on the menu.
Viewing and Changing Sensor Settings
When you finish making settings for a sensor, you are taken to a screen like the one shown in
Figure 5-30, which displays all your sensor settings.
This screen also displays whenever you select a programmed sensor on the Die Protection
Sensor Menu.
To change sensor settings, do the following:
1.
On the Sensor Settings screen, select the setting you want to change. The screen on which
that setting is programmed displays. For example, if you select the SENSOR NAME
setting, the Sensor Names screen (Figure 5-22, page 5-22) displays.
For more information about Green Special sensors, refer to
Understanding Sensor Terminology
,
page 5-16.
Figure 5-30. Sensor Settings Screen
NOTICE