Wintriss SmartPAC 2, User Manual

Page: 266 / 604

1128600 SmartPAC 2 with WPC 2000 Integration User Manual
5-12 Program Mode
1.
On the Counters screen, select the setting displayed in the COUNT column of the counter
you want to adjust. The Numeric Entry window (see Figure 5-3, page 5-3) displays.
2.
Key in a new value, following the directions in the window, and press ENTER. The
window shown in Figure 5-13 displays, asking you to confirm that you want to change the
COUNT value.
3.
Press the Up (

) cursor key to proceed with the Change Count process. The value you
entered in step 2 displays in the COUNT field for the counter you selected in step 1.
4.
Repeat steps 1 through 3 for each count you want to change.
Clearing the Total Hits Counter
Since the Total Hits counter does not reset to zero (0) when its preset has been reached, you
must reset the counter manually. To do so, perform the following steps:
1.
On the Counters screen, select the setting displayed in the COUNT column for TOTAL
HITS.
2.
Press the CLEAR key. The Change Count Confirmation window (see Figure 5-13)
displays, asking you to confirm that you want to change the COUNT value.
3.
Press the Up (

) cursor key to proceed with the Change Count process and clear the Total
Hits count. The value in the COUNT column for TOTAL HITS is reset to zero (0).
ARE YOU “LOCKED OUT”?
If you cannot change count values, security access for the CHANGE COUNT function may be set
to NO CHANGES ALLOWED. See
SECURITY ACCESS
, page 4-47.
You can return a count to zero by simply moving the highlight bar to the appropriate
COUNT field and pressing the CLEAR key.
Figure 5-13. Change Count Confirmation Window
NOTICE
NOTICE