Wintriss autoset 1500, User Manual

Page: 42 / 102

1137200 AutoSet User Manual
2-22 Installation
3.
Remove the connector from the TB101B or TB101A terminal block, and connect wiring
for the oscilloscope as shown in Table 2-8. On Auto Set 1500 and 1500 Plus models you
connect three wires, one for each of the two strain links and one for ground. On AutoSet
1504 and 1504 Plus units, you connect five wires, one for each of the four strain links and
one for ground.
Refer to Figure 2-7, page 2-9 if you need help connecting the wires to the terminals.
Make sure not to wire the connector backwards.
4.
Plug the connector back into the TB101B or TB101A terminal block. The connector can
be plugged in only one way. Check the wiring connections to make sure they are correct.
5.
Connect the wires from TB101B or TB101A to the oscilloscope, following the
manufacturer’s instructions for your specific oscilloscope.
Wiring a Setup Mode Circuit (AutoSet Plus Only)
The Setup Mode function, which disables repeatability monitoring when the press is set to
Inch mode, is available only on AutoSet Plus. Typically the Setup Mode circuit is connected
to the “Inch” position of your clutch/brake control. When you run the press in Inch mode,
AutoSet Plus does not generate a repeatability fault and stop the press.
To wire a Setup Mode circuit, do the following:
1.
Open the cover of the AutoSet enclosure, and locate terminal block TB101B (AutoSet
1500 Plus) or TB101A (AutoSet 1504 Plus) at the lower left of the AutoSet processor
board, referring to Figure 2-4 or Figure 2-5.
2.
Run wiring from the “Inch” circuit of your press control or other device through flexible,
liquid-tight conduit to the bottom left knockout on the AutoSet enclosure or to the
appropriate location on your console. Measure and cut the cable so it reaches TB101B or
TB101A easily.
3.
Remove the connector from the TB101B or TB101A terminal block, and connect wiring
from the Inch circuit of your press control as shown in Table 2-9, page 2-23. You connect
two wires.
Table 2-8. Oscilloscope Wiring Connections, TB101B or TB101A
AutoSet Model Terminal Block Pin # Label
1500 or 1500 Plus TB101B 5 Ground
6 Channel 1 (Left Rear)
7 Channel 2 (Right Rear)
1504 or 1504 Plus TB101A 6 Channel 1 (Left Rear)
7 Channel 2 (Right Rear)
8 Channel 3 (Left Front)
9 Channel 4 (Right Front)
10 Ground