3
Safety Information
Before installation/maintenance, ensure tractor and attachment are
stationary with the hydraulic lift system in a neutral position, and the
ignition key removed. Read and understand this manual before
operating any machinery to avoid equipment damage. Failure to
follow all safety standards can result in severe injury or death.
1.
Regularly check condition and service of your attachment.
2.
Regularly check/tighten all bolts, nuts and screws.
3.
Never consume alcohol/drugs while operating machinery.
4.
This attachment is for use with compact tractors only, within the power
range specified, and at the recommended speed at all times.
5.
Always keep the PTO output from the tractor at 540 rpm. Reduce the
speed when working on hillsides/rough terrain.
6.
Only use for the indicated purpose. Do not use to transport personnel
or livestock. When travelling, keep the PTO turned off.
7.
Always wear protective gloves, ear and eye protection and tie back long
hair. Do not wear loose clothing.
8.
Check the operating area is clear of debris that can cause damage.
9.
Keep spectators at a safe distance.
10.
Do not run the engine in an enclosed area.
11.
Do not leave any machinery unattended while operating.
12.
Do not touch moving parts.
13.
Stop the engine immediately if excessive vibration occurs.
14.
Ensure the engine is switched off before any maintenance. Be aware
components can be hot after operation.
15.
Always repair/replace any defective parts.
16.
Pay attention to any sharp/pointed parts when servicing.
17.
Do not modify the attachment in any way as this may impair the
operation and overall safety.
18.
Ensure all safety guards are in place and in good condition.
19.
Keep all safety signs clean and legible. Replace missing/illegible signs.
4
Safety Information (continued)
Attachment Pre
-
Use Checks
Upon receipt of your new attachment and again within the first 4 hours of
use (the
‘
shake in
’
period), we recommend the following:
1.
Check/tighten all bolts, nuts and screws (and those securing blades).
2.
Check the tension of any belt(s), and adjust if required.
3.
Apply grease to grease points if necessary.
4.
Check engine oil level, top
-
up if required but do not overfill.
Tractor Pre
-
Use Checks
1.
Check the attachment is properly attached to the tractor. Ensure
secure pins are used on the linkage mounting pins.
2.
Add extra weights to the front of the tractor (or wheel weights) if
required.
3.
Check the tractor PTO turns freely and the attachment
’
s PTO drive
shaft can extend easily. Apply grease to PTO drive shaft.
4.
Check the chain of the PTO shaft is in good condition, and attach
chain to a secure point on the tractor.
5.
Before installing the PTO shaft, the tractor and attachment should be
stationary, with the key removed from the ignition.
6.
Install/secure all safety guards, doors and covers before operating.
7.
Bystanders should leave the immediate area before connecting the
drive from the tractor.
Post
-
Use Regular Checks
Safety precaution: Be aware components can be hot after operation.
Allow attachment to cool before performing checks.
1.
Check blades, belts and wearing parts. Ensure they are not damaged
and blades are secure in their mounts. Repair or replace as required.
2.
Clean the attachment, and check for/clear any entangled material
around any moving parts.
3.
Check rotor and roller bearings, apply grease if required.
